Transmission Selection for Conveyor Corners

PVFD090 + 750W Servo, or KRV050, Select by Available Installation Space, Load, Choose according to speed and right-angle drive arrangement.

Motor Power750W Example

Recommended StructurePVFD / KRV

Key ParametersSpace / Continuous Operation / Thermal Load

Output90°Direction Change

WORKING CONDITIONS

What Matters Most When Selecting for This Application?

Start with available space at the conveyor corner: Whether It Is Required 90°Direction Change, Whether a Hollow Bore Is Needed, How to Arrange the Output Shaft Direction.
Consider thermal load during continuous operation, Efficiency & Bearing Loads.
For rapid conveyor starts and stops, also check peak torque, Do Not Select by Average Load Alone.

PVFD090 / KRV050

750W Servo

WHY THIS STRUCTURE

Redirects Power by 90°, Helps position the motor inside the frame and reduce station space.

Efficiency of Different Right-Angle Designs, Accuracy and cost priorities differ, Compare with continuous operating time in mind.

Suitable for Speed Following & Positioning Control, Also Check Roller Diameter, Loaded Starting & Stall Risk.

SELECTION CHECKLIST

LoadWeight, Dimensions, Lever Arm, Center of Gravity

MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time

Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours

AccuracyPositioning Accuracy, Repeatability, Allowable Backlash

MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing

InstallationSpace, Orientation, Radial/Axial Force, Offset Load