Transmission Selection for Dispensing Rotary Axes

PLF060-5-S2-P2 + 400W Servo, Focus on Low-Speed Stability, Backlash, Turntable Inertia & Dispensing Path Consistency.

Motor Power400W Common

Recommended Ratio5:1 Example

Key ParametersLow-Speed Stability / Backlash / Inertia

Operating ConditionsSmall-Angle Reciprocation / Frequent Positioning

WORKING CONDITIONS

What Matters Most When Selecting for This Application?

Dispensing rotary axes often operate at low speed, With small-angle reciprocation and frequent positioning.
Low backlash alone is insufficient if structural rigidity is overlooked, Couplings & Control Settings, The actual motion path may still have errors.
For eccentric loads, calculate turntable inertia and the offset load application point together.

PLF060-5-S2-P2

400W Servo

WHY THIS STRUCTURE

Reduces Rotary Axis Size, Allows Space around Fixtures, Cameras & Dispensing Valves.

For sensitive path joints and repeatable starting points, Compare Backlash More Closely, Rigidity & Control Compensation.

Supports both slow uniform dispensing and rapid return movements, But fixture inertia must still be checked.

SELECTION CHECKLIST

LoadWeight, Dimensions, Lever Arm, Center of Gravity

MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time

Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours

AccuracyPositioning Accuracy, Repeatability, Allowable Backlash

MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing

InstallationSpace, Orientation, Radial/Axial Force, Offset Load