Transmission Selection for Packaging Cross-Sealing

SE075-750W + PLF090-5, For continuous high-speed reciprocation, focus on thermal load, Peak Torque & Sealing/Cutting Synchronization.

Motor750W Servo

Recommended ModelPLF090-5

Key ParametersPeak Torque / Temperature Rise

Operating ConditionsContinuous High Speed / Cyclic Acceleration & Deceleration

WORKING CONDITIONS

What Matters Most When Selecting for This Application?

Cross-sealing axes often operate continuously at high speed, With cyclic acceleration and deceleration, Peak torque may be significantly higher than average torque.
The sealing and cutting mechanism must synchronize with film feed speed, Mechanical backlash and control settings both affect seal position.
During prolonged high-speed operation, monitor gearbox temperature and lubrication.

PLF090-5

750W Servo

WHY THIS STRUCTURE

The square-flange structure integrates easily into cross-sealing axes, A candidate for standardized general-purpose packaging platforms.

It can maintain a relatively high cycle speed, While increasing output torque; Final checks must consider sealing/cutting peaks and thermal load.

The same mechanical platform can accommodate different motor interfaces, Reduce drawing revisions and spare-part varieties.

SELECTION CHECKLIST

LoadWeight, Dimensions, Lever Arm, Center of Gravity

MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time

Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours

AccuracyPositioning Accuracy, Repeatability, Allowable Backlash

MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing

InstallationSpace, Orientation, Radial/Axial Force, Offset Load