Skip to content
ANDANTEX / PRECISION TRANSMISSIONSelection Support / 3D Resources / Custom Engineering
Home / Applications / Indexing Turntable
INDEXING

Indexing Turntable

By Load Diameter, Center of Gravity, Offset Load, Use angle and cycle time to calculate overturning moment and inertia.

Motor Match by Application
Recommended Model Hollow Rotary Table
Key Parameters Overturning Moment / Inertia
Operating Conditions Intermittent Indexing / Offset Load
WORKING CONDITIONS

What Matters Most When Selecting for This Application?

  • Total Weight Is Not the Only Factor, The farther the load is from the rotation center, The greater the rotational inertia.
  • Offset loads create overturning moments, Check the allowable values for the table bearings.
  • The shorter the positioning time, The higher the acceleration/deceleration torque, A larger frame or more rigid structure may be needed.

Recommended Combination

NT / PAG / PLX

Determine from Load & Cycle Requirements

View Product Resources
CONTACT

Location & Contact

Dongguan Hanrui Automation Technology Co., Ltd.

6th Floor, No. 172 Chonghuan Middle Road, Shijie Town, Dongguan, China

Phone: +86 769 8281 3091

Email: oliver@andantexcn.com

WHY THIS STRUCTURE

Why This Transmission Structure Is Recommended?

For hollow cable routing and direct load support, consider NT Series

Integrated Bearing & Mounting Table, Reduces External Support Structures, Leaves a central passage for cables and pneumatic lines.

For high-rigidity disc-flange output, consider PLX

Disc flanges simplify turntable connection, For higher loads, still verify the offset radius and overturning moment.

Square-Flange Structure, For general installation and cost priorities, consider PAG

Suitable where external bearings or a turntable structure already exist, Balances general-purpose interfaces with precision performance.

SELECTION CHECKLIST

Information to Include in Your Selection Request

LoadWeight, Dimensions, Lever Arm, Center of Gravity
MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time
Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours
AccuracyPositioning Accuracy, Repeatability, Allowable Backlash
MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing
InstallationSpace, Orientation, Radial/Axial Force, Offset Load

ANDANTEX Product search

Catalogue guide · Beta
Guided catalogue search by model code — not AI chat. Searches are not stored.