Gearbox Selection for Woodworking Feed Axes | ANDANTEX

PLM090-7 or PAW090-7 + 750W Servo, Check Shock Loads & Dusty Environments.

Motor750W Servo

Recommended ModelPLM090-7 / PAW090-7

Key ParametersShock Load / Protection

Operating ConditionsContinuous Feeding / Dusty Environment

WORKING CONDITIONS

What Matters Most When Selecting for This Application?

Feed axes require stable linear speed, Loads may change suddenly as material enters the cutting area.
In dusty woodworking environments, pay attention to sealing, Protection & Long-Term Lubrication.
For Lower Noise, And Smoother Transmission, Consider a Helical Precision Planetary Series.

PLM090-7 / PAW090-7

750W Servo

WHY THIS STRUCTURE

Smoother transmission helps control feed fluctuations, Actual Accuracy Also Depends on Rollers, Guides & Resistance from the Material.

Maintains a Useful Feed Speed, While Increasing Resistance to Load; Check Peak Torque against Maximum Cutting Resistance.

A Typical Power Rating Helps Initial Selection, Final Selection Must Still Consider Roller Diameter, Clamping Force & Acceleration Time.

SELECTION CHECKLIST

LoadWeight, Dimensions, Lever Arm, Center of Gravity

MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time

Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours

AccuracyPositioning Accuracy, Repeatability, Allowable Backlash

MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing

InstallationSpace, Orientation, Radial/Axial Force, Offset Load