Skip to content
ANDANTEX / PRECISION TRANSMISSIONSelection Support / 3D Resources / Custom Engineering

Gearbox Selection and Installation FAQ

Browse questions by topic or open the related technical article for more detail.

Found 11 questions.

Is a 5:1 gearbox faster than a 10:1 gearbox?

Yes. At the same motor input speed, a 5:1 gearbox has twice the output speed of a 10:1 gearbox.

Read the related article
Does a 10:1 gearbox always provide more output torque?

A higher ratio increases theoretical torque multiplication, but the available output torque remains limited by the gearbox ratings and operating conditions.

Read the related article
Does the absence of servo alarms mean the gearbox is within its limits?

No. A servo drive can operate without an alarm while gearbox loads exceed the permitted limits. Check the gearbox torque, speed, load and duty conditions separately.

Read the related article
Is a longer acceleration time always better?

No. Select acceleration and deceleration times that meet the machine cycle while keeping peak loads and mechanical shock within the specified limits.

Read the related article
Is slight gear noise normal in a new gearbox?

Check the product structure, speed and applicable noise limits. Investigate a sudden increase in noise.

Read the related article
Is temperature rise after installation normal?

Measure the temperature and review the load, operating time and model limits. Touch alone cannot establish whether the temperature is acceptable.

Read the related article
Does P0 guarantee better machine positioning accuracy than P2?

A lower gearbox backlash value alone does not guarantee better machine positioning accuracy. The complete mechanical and control system determines the result.

Read the related article
Do all 750 W motors have the same mounting interface?

No. Motor interfaces can differ between brands and between series from the same brand. Compare the actual drawings.

Read the related article
Can peak torque be sustained continuously?

No. Peak torque is an intermittent limit. Check its permitted duration and duty conditions in the model documentation.

Read the related article
Does a 400 W servo motor always require a PLF060 gearbox?

No. The load, ratio, peak torque, motor interface and accuracy requirements determine the selection. Review the appropriate PLF, PAG, PLX or other model against the complete duty.

Read the related article
Do all 750 W servo motors use the same flange?

No. Flange dimensions, shaft diameter, pilot diameter and mounting hole spacing can differ between motor brands and series. Check the actual motor drawing.

Read the related article

ANDANTEX Product search

Catalogue guide · Beta
Guided catalogue search by model code — not AI chat. Searches are not stored.