Home / Applications / Vision Inspection Turntable
VISION
Vision Inspection Turntable
NT200-10 + 400W Servo, Check Inertia, Offset Load, Positioning & Acceleration Time.
Motor 400W Servo
Recommended Model NT200-10
Key Parameters Inertia / Offset Load / Positioning
Operating Conditions Cyclic Starts & Stops / Direct Load Support
WORKING CONDITIONS
What Matters Most When Selecting for This Application?
- Total weight alone is insufficient for a vision turntable, Consider Load Radius, Center of Gravity & Offset Load Position.
- The shorter the positioning time, Acceleration/Deceleration Torque Increases, Check Rotational Inertia & Peak Torque.
- Hollow tables suit camera systems, Cables, Pneumatic Lines through the Center, Reduces External Cable-Chain Interference.
CONTACT
Location & Contact
Dongguan Hanrui Automation Technology Co., Ltd.
6th Floor, No. 172 Chonghuan Middle Road, Shijie Town, Dongguan, China
Phone: +86 769 8281 3091
Email: oliver@andantexcn.com
WHY THIS STRUCTURE
Why This Transmission Structure Is Recommended?
NT The series integrates support bearings, Gear Reduction & Mounting Table
Reduces Part Count & Sources of Assembly Error, Positions the camera station and fixture around one rotary reference.
The large hollow bore accommodates vision cables and pneumatic lines
Cables Do Not Need to Pass around the Outside, Reduces cable-chain interference and simplifies wiring during repeated indexing.
Direct turntable mounting reduces couplings and additional supports
More Compact Structure, But Table Diameter, Load center of gravity and offset moment must be calculated for the actual fixture.
SELECTION CHECKLIST
Information to Include in Your Selection Request
LoadWeight, Dimensions, Lever Arm, Center of Gravity
MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time
Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours
AccuracyPositioning Accuracy, Repeatability, Allowable Backlash
MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing
InstallationSpace, Orientation, Radial/Axial Force, Offset Load






