Skip to content
ANDANTEX / PRECISION TRANSMISSIONSelection Support / 3D Resources / Custom Engineering

Does High Gearbox Temperature Always Indicate a Quality Problem?

Check the load factor first, Lubrication, Concentricity, Installation Environment & Acceleration/Deceleration Time, Then investigate possible internal faults

Key Takeaway:Check the load factor first, Lubrication, Concentricity, Installation Environment & Acceleration/Deceleration Time, Then investigate possible internal faults.

Check the Load First

Operating Near or above Rated Load for Long Periods, Significantly increases gear and bearing losses.

Then Check the Installation

Poor Motor-to-Gearbox Concentricity, Mounting face deformation or excessive external radial force can cause abnormal heating.

Check Dynamic Operating Conditions

Acceleration/Deceleration Time Too Short, Frequent starts and stops increase instantaneous torque and thermal load.

When to Suspect an Internal Fault?

After Ruling Out Operating & Installation Problems, If abnormal temperature rise continues with noise, Vibration or Lubrication Problems, Inspect Internal Components Further.

How to Apply This Information to Selection?

Do not make a final selection from a single parameter. Review the motor model, Load, Target Output Speed, Torque, Inertia, Check acceleration/deceleration time and mounting interfaces together, Then select the series and model.

Related FAQ

Is temperature rise after installation normal?

Measure the temperature and review the load, operating time and model limits. Touch alone cannot establish whether the temperature is acceptable.

Read the related article
ENGINEERING SUPPORT

Need Help Applying This Information?

Send your application, motor details or drawing. The enquiry automatically records this article as its source.

Ask an EngineerBrowse Related Products2D / 3D Resources [STEP / PDF]
TECHNICAL DISCUSSION

Technical Questions & Discussion

Ask a technical question about this article. Names and questions may be published after review; email addresses are never displayed.

No published questions yet. Be the first to ask.

Leave a Technical Question

Required fields are marked *. Questions are reviewed before publication when comments are enabled.

KEEP READING

How to Diagnose Increasing Gearbox Noise?

Begin by examining gear meshing, Bearing, Mounting Rigidity, Concentricity, Check load changes and lubrication conditions step by step.

Read Article

ANDANTEX Product search

Catalogue guide · Beta
Guided catalogue search by model code — not AI chat. Searches are not stored.