Home / Applications / Conveyor Corner Drive
CONVEYOR
Conveyor Corner Drive
PVFD090 + 750W Servo, or KRV050, Choose by Space & Load.
Motor 750W Servo
Recommended Model PVFD090 / KRV050
Key Parameters Installation Space / Load
Operating Conditions Continuous Conveying / 90° Direction Change
WORKING CONDITIONS
What Matters Most When Selecting for This Application?
- Start with available space at the conveyor corner: Whether It Is Required 90°Direction Change, Whether a Hollow Bore Is Needed, How to Arrange the Output Shaft Direction.
- Consider thermal load during continuous operation, Efficiency & Bearing Loads.
- For rapid conveyor starts and stops, also check peak torque, Do Not Select by Average Load Alone.
CONTACT
Location & Contact
Dongguan Hanrui Automation Technology Co., Ltd.
6th Floor, No. 172 Chonghuan Middle Road, Shijie Town, Dongguan, China
Phone: +86 769 8281 3091
Email: oliver@andantexcn.com
WHY THIS STRUCTURE
Why This Transmission Structure Is Recommended?
PVFD Suitable for Compact Right-Angle Drives
Redirects Power by 90°, Helps position the motor inside the frame and reduce station space.
KRV Hypoid designs can suit compact right-angle transmission, Low-Noise Applications
Efficiency of Different Right-Angle Designs, Accuracy and cost priorities differ, Compare with continuous operating time in mind.
750W Servo motors suit conveyor stations requiring speed synchronization and positioning
Suitable for Speed Following & Positioning Control, Also Check Roller Diameter, Loaded Starting & Stall Risk.
SELECTION CHECKLIST
Information to Include in Your Selection Request
LoadWeight, Dimensions, Lever Arm, Center of Gravity
MotionTarget Speed, Angle, Travel, Acceleration & Deceleration Time
Cycle TimeTime per Cycle, Start/Stop Frequency, Daily Operating Hours
AccuracyPositioning Accuracy, Repeatability, Allowable Backlash
MotorPower, Model, Shaft Diameter, Shaft Length, Pilot Diameter, Hole Spacing
InstallationSpace, Orientation, Radial/Axial Force, Offset Load






