PVFG Double-Bore Output Right-Angle Gearboxes

Selecting a PVFG Double-Bore Output Gearbox

PVFG combines coupling-bore input with double-bore output. The input bore connects to the servo motor through a coupling; the output bores are the machine-side interfaces. Identify both sets of dimensions separately when preparing a selection request.

• Mating shafts: provide the shaft drawing for each output connection, including diameter, engagement length and the required locating and fastening details.
• Bore connection: confirm the actual output connection design and fit from the selected model drawing. The term bore output alone does not specify a keyway, spline or clamping arrangement.
• Assembly and loads: check access to both output sides and describe the external supports, alignment arrangement and load cycle for each connected shaft.

Check the Combined Load on Both Output Sides

The rated output torque is the combined limit for both sides, not a separate full rating for each side. Do not assign the full rated torque independently to both loads or assume that the load always divides equally. Provide the load on each side and confirm the combined requirement against the selected model rating.

Motor Matching and Information for Selection

Provide the complete servo motor model and drawing. Check shaft diameter, usable shaft length, locating pilot and mounting-hole pattern using the motor interface dimensions checklist. Motor power alone does not confirm mechanical compatibility.

Include the required ratio or output speed, working and peak torque requirements, acceleration/deceleration cycle and installation drawing. Confirm available ratios and ratings for the exact model. Request a PVFG model and drawing review.

Compare Other Output Arrangements

If the required output connection differs, compare PVFGB single-bore output and PVFH double-shaft output. Review the right-angle gearbox connection comparison before choosing a series. A different series requires a fresh check of dimensions and load ratings.