FAQ

Find Questions & Answers by Category, Or Read the Related Technical Article.

Total 11 EntriesQuestions & Answers

5:1 Compared with 10:1 Is It Faster?

At the Same Motor Input Speed, Yes, 5:1 Output Speed Is Approximately 10:1 Twice That of.

10:1 Does It Always Provide More Torque?

The theoretical torque multiplication is greater, But available torque is still limited by the gearbox rated capacity / Peak Torque Limit.

Does the Absence of Servo Alarms Mean the Gearbox Is Safe?

Not Necessarily. Servo capacity does not guarantee acceptable gearbox peak loads or service life.

Is Longer Acceleration Time Always Better?

No. Balance Machine Cycle Time & Mechanical Shock.

Is Slight Gear Noise Normal in a New Gearbox?

Consider the Product Structure, Speed & Applicable Noise Limits; A sudden increase in noise deserves closer investigation.

Is Heating Immediately after Installation Normal?

Consider the Actual Temperature, Load & Operating Time, Do Not Rely Solely on " Feels Hot to the Touch " To Judge Product Quality.

P0 Is It Necessarily Better than P2 More Accurate Positioning?

The gearbox itself has lower backlash, But final machine accuracy depends on the complete mechanical and control system.

Even at the Same 750W Are All Motor Interfaces Identical?

No. Different Brands, Interfaces may differ across series, even within one brand.

Can Peak Torque Be Sustained Continuously?

No. Peak torque is generally allowed only briefly, Refer to product technical documents for allowable duration.

400W Must a Servo Use PLF060 Question?

Not Necessarily. Load, Gear Ratio, Peak Torque, Interface and accuracy requirements differ, May Require PAG, PLX Or Another Frame Size.

750W Does a Servo Always Have 90 This Flange?

Do Not Assume This. Flanges Differ between Brands & Series, Shaft Diameter, Pilot Diameter & Hole Spacing May Differ, Check the Drawing.