Skip to content
ANDANTEX / PRECISION TRANSMISSIONSelection Support / 3D Resources / Custom Engineering

Why Motor Power Alone Is Not Enough to Select a Planetary Gearbox?

Motors with the same power may have different speeds, Inertia & Peak Capability, Select the gearbox based on output torque, Gear Ratio, Determine inertia and interface requirements together

Key Takeaway:Motors with the same power may have different speeds, Inertia & Peak Capability, Select the gearbox based on output torque, Gear Ratio, Determine inertia and interface requirements together.

Why the Same Power, Can Produce Very Different Results?

Motor power is the product of speed and torque. Identical 750W Motor, If Rated Speed, Peak Torque, Or Rotor Inertia Differs, The gearbox input conditions also differ.

Which Parameters Must Be Checked Together?

Confirm Motor Rated Speed, Reduction Ratio, Required Output Torque, Peak Torque, Load Inertia, Acceleration & Deceleration Time, Radial / Axial Force & Motor Interface.

When Can Power Be the First Step?

Use power to estimate the frame range during initial screening, For Example 400W Common 60 Frame Size, 750W Common 90 Frame Size, But This Alone Cannot Determine the Final Model.

How to Apply This Information to Selection?

Do not make a final selection from a single parameter. Review the motor model, Load, Target Output Speed, Torque, Inertia, Check acceleration/deceleration time and mounting interfaces together, Then select the series and model.

Related FAQ

Does a 400 W servo motor always require a PLF060 gearbox?

No. The load, ratio, peak torque, motor interface and accuracy requirements determine the selection. Review the appropriate PLF, PAG, PLX or other model against the complete duty.

Read the related article
Do all 750 W servo motors use the same flange?

No. Flange dimensions, shaft diameter, pilot diameter and mounting hole spacing can differ between motor brands and series. Check the actual motor drawing.

Read the related article
ENGINEERING SUPPORT

Need Help Applying This Information?

Send your application, motor details or drawing. The enquiry automatically records this article as its source.

Ask an EngineerBrowse Related Products2D / 3D Resources [STEP / PDF]
TECHNICAL DISCUSSION

Technical Questions & Discussion

Ask a technical question about this article. Names and questions may be published after review; email addresses are never displayed.

No published questions yet. Be the first to ask.

Leave a Technical Question

Required fields are marked *. Questions are reviewed before publication when comments are enabled.

KEEP READING

Gearbox Output Shaft Radial Load: A Timing-Belt Pulley Example

A timing pulley on a gearbox output transmits torque, but it also pulls sideways on the output shaft. That radial load acts on the shaft and its bearings.…

Read Article

How to Size an AGV Wheel-Drive Gearbox: A 600 kg Example

To size an AGV wheel-drive gearbox, start with the total moving mass, required vehicle speed, wheel diameter, slope and acceleration. Use those inputs to estimate wheel speed and…

Read Article

Hollow Shaft vs Solid Shaft Right-Angle Gearboxes: Which Output Fits Your Machine?

When choosing a right-angle gearbox, the output connection determines how the gearbox fits the machine and how the load reaches its bearings. A hollow output receives a mating…

Read Article

ANDANTEX Product search

Catalogue guide · Beta
Guided catalogue search by model code — not AI chat. Searches are not stored.