Skip to content
ANDANTEX / PRECISION TRANSMISSIONSelection Support / 3D Resources / Custom Engineering

How Frequent Starts and Stops Affect Gearbox Life?

Frequent acceleration and deceleration create repeated peak loads, And increase gear loading, Thermal and mechanical loads on bearings and lubrication systems

Key Takeaway:Frequent acceleration and deceleration create repeated peak loads, And increase gear loading, Thermal and mechanical loads on bearings and lubrication systems.

Increased Mechanical Shock

Each Start, Braking and reversing generate inertial torque, The higher the frequency, The more load cycles gears and bearings experience.

Temperature Rise Can Also Increase

Frequent acceleration and deceleration increase losses, Even When the Average Load Is Low, Accumulated heat can raise the temperature.

How to Improve?

Increase Acceleration/Deceleration Time, Increase the Gearbox Safety Margin, Optimize Inertia Matching, Check for Excessive Load Inertia.

How to Apply This Information to Selection?

Do not make a final selection from a single parameter. Review the motor model, Load, Target Output Speed, Torque, Inertia, Check acceleration/deceleration time and mounting interfaces together, Then select the series and model.

Related FAQ

Is a longer acceleration time always better?

No. Select acceleration and deceleration times that meet the machine cycle while keeping peak loads and mechanical shock within the specified limits.

Read the related article
ENGINEERING SUPPORT

Need Help Applying This Information?

Send your application, motor details or drawing. The enquiry automatically records this article as its source.

Ask an EngineerBrowse Related Products2D / 3D Resources [STEP / PDF]
TECHNICAL DISCUSSION

Technical Questions & Discussion

Ask a technical question about this article. Names and questions may be published after review; email addresses are never displayed.

No published questions yet. Be the first to ask.

Leave a Technical Question

Required fields are marked *. Questions are reviewed before publication when comments are enabled.

KEEP READING

Gearbox Output Shaft Radial Load: A Timing-Belt Pulley Example

A timing pulley on a gearbox output transmits torque, but it also pulls sideways on the output shaft. That radial load acts on the shaft and its bearings.…

Read Article

How to Size an AGV Wheel-Drive Gearbox: A 600 kg Example

To size an AGV wheel-drive gearbox, start with the total moving mass, required vehicle speed, wheel diameter, slope and acceleration. Use those inputs to estimate wheel speed and…

Read Article

Hollow Shaft vs Solid Shaft Right-Angle Gearboxes: Which Output Fits Your Machine?

When choosing a right-angle gearbox, the output connection determines how the gearbox fits the machine and how the load reaches its bearings. A hollow output receives a mating…

Read Article

ANDANTEX Product search

Catalogue guide · Beta
Guided catalogue search by model code — not AI chat. Searches are not stored.