PRECISION DRIVE
Knowledge Center
Browse Selection Topics, Parameters, Installation, Maintenance & Company/Product Updates.
Total 8 EntriesArticle
How to Choose a Heavy-Duty Hollow Rotary Table for a Flipping Mechanism
A practical HTM selection guide for flipping fixtures: separate gravity torque, acceleration, bearing loads and holding requirements, then verify the motor interface and drawing.
Read More →Selection BasicsPlanetary Gearboxes for Servo Motors: Series and Selection
Compare ANDANTEX planetary gearbox series for servo-driven automation. Start with the transmission arrangement and output connection, then check ratio, torque, positioning requirements and the exact motor interface. This overview brings together standard, precision, flange-output and right-angle planetary gearboxes. PLF060 representative product photo; calculations in this article are illustrative and are not product ratings. Choose a…
Read More →Selection BasicsHow to Select and Install a Hollow Rotary Table
A hollow rotary table combines a large central opening with a rigid rotary output. The opening can route cables, air lines, vacuum tubes, optical fibers or inspection paths through the axis, while the table supports a fixture, camera, dial plate or workpiece. ANDANTEX HTM representative heavy-duty hollow rotary table. Confirm the exact model and interface…
Read More →Selection BasicsRight-Angle Planetary Gearboxes for Servo Applications
Compare PVEA, PVFA, PAMG and PVMG right-angle planetary gearboxes. Check output layout, torque, ratio and motor interfaces for your servo application.
Read More →Selection Basics8 Types of Gear Drives: Comparison and Selection
Compare eight types of gear drives, their shaft layouts and selection tradeoffs. Check torque, duty cycle and output loads for industrial automation.
Read More →Selection BasicsHow Short Acceleration Times Affect a Gearbox?
The shorter the acceleration time, The higher the inertial torque, May trigger alarms, Shock Loads, Noise, Temperature rise or reduced service life.
Read More →Selection BasicsHow Frequent Starts and Stops Affect Gearbox Life?
Frequent acceleration and deceleration create repeated peak loads, And increase gear loading, Thermal and mechanical loads on bearings and lubrication systems.
Read More →Selection BasicsWhy Motor Power Alone Is Not Enough to Select a Planetary Gearbox?
Motors with the same power may have different speeds, Inertia & Peak Capability, Select the gearbox based on output torque, Gear Ratio, Determine inertia and interface requirements together.
Read More →