PVFH Double-Shaft Output Right-Angle Gearboxes
ANDANTEX PVFH right-angle gearboxes use coupling-bore input and double-shaft output. Select a model to review motor interfaces, dimensional drawings and available 3D STEP files. Both output sides can drive loads simultaneously. The rated output torque is the combined limit for both sides, not a separate full rating for each side.
Model / Specifications
← BackRight Angle GearboxFor motor connection terminology and interface checks, read the guide to coupling-bore, splined-bore, keyed-bore and shaft inputs.

PVFH040 Double-Shaft Output Right-Angle Gearbox
View Specifications & Resources
PVFH060 Double-Shaft Output Right-Angle Gearbox
View Specifications & Resources
PVFH090 Double-Shaft Output Right-Angle Gearbox
View Specifications & ResourcesSelecting a PVFH Double-Shaft Output Gearbox
PVFH uses coupling-bore input and output shafts on both sides. Both output sides can drive loads simultaneously. Prepare a layout showing each driven connection so the selected model can be checked against the two sides of the machine.
- Shaft connections: check the diameter, usable length and specified connection features on each output side against the mating components.
- Two-sided layout: include assembly clearance and any external supports or overhung components on both sides, rather than checking only the motor side.
- Operating sequence: provide the torque and motion cycle for each driven side, including periods when both sides are loaded and any unequal loading.
Check the Combined Load on Both Output Sides
The rated output torque is the combined limit for both sides, not a separate full rating for each side. Do not assign the full rated torque independently to both loads or assume that the load always divides equally. Provide the load on each side and confirm the combined requirement against the selected model rating.
Motor Matching and Information for Selection
Provide the complete servo motor model and drawing. Check shaft diameter, usable shaft length, locating pilot and mounting-hole pattern using the motor interface dimensions checklist. Motor power alone does not confirm mechanical compatibility.
Include the required ratio or output speed, working and peak torque requirements, acceleration/deceleration cycle and installation drawing. Confirm available ratios and ratings for the exact model. Request a PVFH model and drawing review.
Compare Other Output Arrangements
If the required output connection differs, compare PVFD single-shaft output and PVFG double-bore output. Review the right-angle gearbox connection comparison before choosing a series. A different series requires a fresh check of dimensions and load ratings.







