Knowledge Center
Browse Selection Topics, Parameters, Installation, Maintenance & Company/Product Updates.
Found 30 articles.
What Does the Planet Carrier Do in a Planetary Gearbox?
A planet carrier supports the planet gears and locates their pins around the sun gear. In a common planetary reduction arrangement with the ring gear fixed and the sun gear driven, the carrier provides the reduced-speed output. Its job is structural as well as rotational: the gear teeth, planet bearings, pins and carrier must work…
Read More Selection BasicsHow to Choose a Heavy-Duty Hollow Rotary Table for a Flipping Mechanism
A practical HTM selection guide for flipping fixtures: separate gravity torque, acceleration, bearing loads and holding requirements, then verify the motor interface and drawing.
Read More Understanding SpecificationsPlanetary Gearbox Design: How It Works and What to Specify
Understand planetary gearbox structure, fixed-ring ratio calculations and the load, precision and interface requirements needed for a machine design.
Read More Selection BasicsPlanetary Gearboxes for Servo Motors: Series and Selection
Compare ANDANTEX planetary gearbox series for servo-driven automation. Start with the transmission arrangement and output connection, then check ratio, torque, positioning requirements and the exact motor interface. This overview brings together standard, precision, flange-output and right-angle planetary gearboxes. PLF060 representative product photo; calculations in this article are illustrative and are not product ratings. Choose a…
Read More Understanding SpecificationsHeavy-Duty Hollow Rotary Tables: Spindle and Load Support
A heavy-duty hollow rotary table must both rotate the fixture and support its working loads. These are separate design checks: enough driving torque does not automatically mean that the output bearing, mounting flange or machine base can support the application. ANDANTEX HTM representative heavy-duty hollow rotary table. Confirm the exact model and interface drawing for…
Read More Selection BasicsHow to Select and Install a Hollow Rotary Table
A hollow rotary table combines a large central opening with a rigid rotary output. The opening can route cables, air lines, vacuum tubes, optical fibers or inspection paths through the axis, while the table supports a fixture, camera, dial plate or workpiece. ANDANTEX HTM representative heavy-duty hollow rotary table. Confirm the exact model and interface…
Read More Understanding SpecificationsPlanetary Gearbox Reduction Ratio: Calculation and L1/L2 Stages
A planetary gearbox reduction ratio compares input speed with output speed. A 10:1 reducer turns its output once for every ten input revolutions. The right ratio must satisfy output speed, torque and the complete motion cycle. How to calculate reduction ratio Ratio i = input speed / output speed. Therefore, output speed = input speed…
Read More Selection BasicsRight-Angle Planetary Gearboxes for Servo Applications
Compare PVEA, PVFA, PAMG and PVMG right-angle planetary gearboxes. Check output layout, torque, ratio and motor interfaces for your servo application.
Read More Selection Basics8 Types of Gear Drives: Comparison and Selection
Compare eight types of gear drives, their shaft layouts and selection tradeoffs. Check torque, duty cycle and output loads for industrial automation.
Read More Understanding Specifications5:1 and 10:1 What Is the Practical Selection Difference?
Increasing the gear ratio reduces output speed, Theoretical output torque increases, Reflected inertia also changes, Dynamic Response & Stage Selection.
Read More Selection BasicsHow Short Acceleration Times Affect a Gearbox?
The shorter the acceleration time, The higher the inertial torque, May trigger alarms, Shock Loads, Noise, Temperature rise or reduced service life.
Read More Selection BasicsHow Frequent Starts and Stops Affect Gearbox Life?
Frequent acceleration and deceleration create repeated peak loads, And increase gear loading, Thermal and mechanical loads on bearings and lubrication systems.
Read More





